We wanted the new VersiFoam website to give our customers and potential customers access to the best product information possible for polyurethane spray foam insulation. So, one of the features we have included is a video library where you can find our how-to, safety, and troubleshooting videos all in one place. If you set aside 30 minutes, you can watch all of the videos in one session and be prepared to begin your residential or commercial insulation project right away.
We recommend you begin with the first video at the top of the page. It is a higher level overview of the VersiFoam product and how to apply it it. You’ll get an introduction to the correct safety equipment and how to wear it. Then, an experienced professional will demonstrate the application process from beginning to end, including how to treat the canisters and how to get the level of thickness you desire. You’ll also get an introduction to our patented U-Control Dispenser and see how the speed of the flow is controlled by the trigger. Toward the end, there is a short demonstration of caulking gaps and filling large voids.
Videos for Large, Medium, and Small Spray Foam Kits
The how-to for medium kits uses the System 15 for illustrative purposes. It includes all of the same training information that is in the large kit how-to video, but the demonstrations are specific to medium sized kits. This gives you an opportunity to see how your kit will behave during use.
All VersiFoam systems are low pressure products. As such they require specific protective equipment which includes chemical resistant safety goggles, chemical resistant protective clothing to prevent skin exposure, chemical resistant nitrile gloves, and a respirator which is approved by the National Institute of Safety and Health. The choice of respirator depends on which system you are using and under what circumstances. All of this is clearly explained and demonstrated in the video on safety equipment, which discusses each of the types of masks and when you should be using them. It also demonstrates how to fit and wear a full mask respirator and what to do if you haven’t achieved a complete seal.
Product Troubleshooting Video Library
Finally, when you are finished for the day, remove the mixing nozzle and apply petroleum jelly to front of gun. Then close the valves and use petroleum jelly on the valve opening. A short two minutes of your time watching the “Shutdown & Storage” video will show you everything you need to know about safely concluding your insulation project. Our video library also includes a Spanish version of “Safety Equipment”, “Product Troubleshooting”, and “Shutdown & Storage.” We invite you to visit the library and see for yourself how easy it is to get started with VersiFoam spray foam insulation kits.
